Star-micronics Serial Interface Unit IS-NP192 Manual de usuario descargar pdf (Pagina 8)

Switch 2: Parity Check

This switch specifies whether or not a parity check should be performed

on the data.

Parity Check SW2 DOS Setting

Disabled ON Disabled

Enabled OFF Enabled

Switch 3: Parity

This switch specifies the parity as non, odd, or even.

Parity SW3 DOS Setting

Odd ON O

Even OFF E

Switch 4: Protocol

Protocol, which is sometimes referred to as “handshaking,” is the com-

munications convention that is used to allow the printer and computer

to regulated the flow of data. DTR is the most commonly used proto-

col.

Protocol SW4 DOS Setting

DTR ON DTR

XON/XOFF OFF XON/XOFF

Switches 5, 6: Not used

BANK B

Switch 1, 2, 3: Baud Rate

The baud rate is the speed, in bits per second, that the printer sends

data to the computer. The common setting is 9600 or 19200.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Star-micronics Serial Interface Unit IS-NP192 Manual de usuario Pagina 8