Star Micronics Multi-Font NX-2415 Manual de usuario descargar pdf (Pagina 37)

Top of form

When you turn on printer power, the top-of-form position is automatically

set to the current position. If this is not where you want the top of the page

to be, you can change the top-of-form position as follows.

1. Press the ( ON LINE > button to set the printer off-line.

2. Move the paper to the desired top-of-form position by pressing the

GAPER FEED’) button, or by performing a forward or reverse micro-feed.

3. Press and hold the ( ON LINE ) button.

4. Press and hold the (PITCH) button.

5. Release both buttons at the same time. The printer will beep to indicate

that the top-of-form position has been set.

Forward micro-feed

For fine alignment, you can feed the paper forward in very small increments

as follows:

1. Press the ( ON LINE > button Lo set the printer off-line.

2. Press the ( ON LINE ) button again and hold it down.

3. Press the (PAPER FEED) button. The paper will start advancing in a series

of small steps. When you want to stop, release both buttons.

Reverse micro-feed

You can also feed the paper in small increments in reverse, to return to a

higher position on the same page.

Note:With fanfold forms, do not try to return to a previous page. The per-

foration may catch inside the printer.

1. Press the ( ON LINE 1 button to set the printer off-line.

2. Press the ( ON LINE > button again and hold it down.

3. Press the ( =VBCCT ) button. The paper will start moving backwards

in a series of small steps. When you want to stop, release both buttons.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 133 134

Sin comentarios

Star Micronics Multi-Font NX-2415 Manual de usuario Pagina 37