Star Micronics TSP400 Manual de usuario descargar pdf (Pagina 12)

– 8 –

SPECIFICATIONS AND OPERATION

Density Adjustment Aperture

About 90˚

Light

Dark

4. Print-Density Adjustment

Adjust the print density in accordance with the sensitivity of the paper being used. The adjustment procedure is as follows.

Fig. 1-5 Print-Density Adjustment

1Remove the interface cover, located the rear side of the printer. The cover fits into place; no screws are used.

2The density adjustor (variable resistor) is now accessible through the aperture located to the left of the interface

connector.

3Insert a screwdriver (regular or phillips-head) into the aperture and rotate as necessary. The adjustor has a

rotational range of approximately 180 degrees.

5Avoid setting density too high for sensitive paper types. Excessive dark values may cause the paper to swell,

degrading the image quality.

6Some thermal papers may fail to produce a strong image when running at 50mm/sec printing speed, even at

maximum density setting. If you have this problem, reduce the print speed to 25mm/sec.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 79 80

Sin comentarios

Star Micronics TSP400 Manual de usuario Pagina 12