Star Micronics TSP400 Manual de usuario descargar pdf (Pagina 15)

– 11 –

SPECIFICATIONS AND OPERATION

6. Setting Memory Switches from the Control Panel

The TSP400 uses EEPROM memory switches in place of corresponding hardware switches. All EEPROM switch settings

can be changed by software. A number of these switches are also changeable from the control panel.

(1) Paper-Feed Mode (Continuous or Next-Top)

When the feed mode is set to next-top, the printer can come online only if loaded with labels or marked paper. If the printer

fails to come online you will not be able to change the feed-mode setting by command; you will therefore have to change

it using the control panel.

1Hold down the FEED and ON LINE buttons while switching on the power, and continue to hold them down until

you hear a double beep. (You will first hear a single beep, followed by a pause, followed by the double beep.)

Release the buttons immediately after hearing the double beep.

2Press the ON LINE button to select continuous feed (the printer beeps once), or press the FEED button to select

next-top feed (the printer beeps twice). If you select next-top feed, the printer automatically starts paper feed

and looks for the next top.

(2) Sensor Mode

The printer may be set to use either the transmissive or the reflective sensor for next-top detection. You can make this

setting as follows.

1Hold down the ON LINE button while switching on the power, then continue to hold it down until you hear a

double beep. (You will first hear a single beep, then a pause, then the double beep.) Release the ON LINE button

immediately after hearing the double beep.

2Press the ON LINE button to select the reflective sensor (the buzzer beeps once), or press the FEED button to

select the transmissive sensor (the buzzer beeps twice).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Sin comentarios

Star Micronics TSP400 Manual de usuario Pagina 15