Star Micronics TSP654II-WebPRNT-2 Manual descargar pdf (Pagina 16)

PAIR

RST

PAIR

RST

PAIRRST

PAIR button

PAIR buttonRST button

LED

3-7. Bluetooth Settings

(For

Bluetooth Interface Models only

)

(2) Pairing will be possible for 60 seconds from when the LED begins ashing green.

During this time, perform pairing from the master device.

Device name: Star Micronics (default)

(3) Aer performing pairing, wait until the LED stops ashing green, or turn the printer o and back on again, to enable

the connection.

In the iOS devices, aer pairing, the LED will automatically begin ashing blue, and the printer will be automatically

connected.

(4) Connect to the printer from the master device application and perform printing. If the printing is successful, the

pairing process has been completed.

Note: e printer performs various processes immediately aer connecting to or disconnecting from a master

device.

Please wait approximately 0.1 seconds aer connecting, and approximately 0.5 seconds aer disconnecting,

before beginning communications with the printer. is wait will ensure that the next action you perform

is executed correctly.

Pair the printer with the master device by following the procedure below.

3-7-1. Pairing using SSP (Simple Secure Pairing) [Default]

(1) Aer turning the printer's power switch on, press and hold the PAIR button on the rear interface of the printer for 5

seconds or more, and then release it. e LED will ash green.

LED

Indicates the status of the Bluetooth interface.

Green (on): Not connected.

Green (ashing): Ready to start pairing.

Blue (on): Connected.

Purple (ashing): Auto connection ON.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Sin comentarios

Star Micronics TSP654II-WebPRNT-2 Manual Pagina 16