Star Micronics TSP654II-WebPRNT-2 Manual descargar pdf (Pagina 8)

Parallel interface cable

Ferrite core

Interface cable

5 cm

(maximum)

Fastener

Pull and cut

3-2.

Connecting the Interface Cable to the Printer

Printer cables are not included in the package.

Obtain an appropriate cable that complies with the specications beforehand.

Because the appropriate interface cable diers depending on the system that you are connecting the printer to, contact

the dealer that you bought the product from if you are unsure about what cable to use.

Before connecting or disconnecting an interface cable, be sure to disconnect the AC adapter’s power cord from the outlet.

3-2-1. Parallel Interface Cable

To connect a parallel cable, follow the procedure given below.

(1) Make sure the printer is turn o.

(2) Ax the ferrite core onto the cable as shown in the illustration.

(3) Pass the fastener through the ferrite core.

(4) Loop the fastener around the cable and lock it. Use scissors to cut

o any excess.

(5) Connect the interface cable to the connector on the rear panel of

the printer.

(6) Fasten the connector clasps.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Sin comentarios

Star Micronics TSP654II-WebPRNT-2 Manual Pagina 8