Star Micronics SM-S220i-DB40 Manual descargar pdf (Pagina 22)

- 15 -

2.5 Belt Clip

2.5.1 Attaching to the Printer

Follow the procedure below to attach the belt clip to the printer.

1. Make sure that you are attaching the belt clip in the right orientation, then screw the screw that

comes with the belt clip into the designated screw hole to attach the belt clip to the printer.

2. Use a screwdriver to rmly screw in the screw.

2.5.2 Using the Belt Clip

When the printer is attached to your belt, you can use it like the picture below.

Hold the printer rmly with your hand when you cut paper. If it is not held rmly, you may cannot

cut paper smoothly with the tear bar.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 30 31

Sin comentarios

Star Micronics SM-S220i-DB40 Manual Pagina 22